本文關鍵詞：FDM分層高度對制品力學性能和表面質量的影響　出處：《塑料》2017年03期 　論文類型：期刊論文

  更多相關文章： FDM 分層高度 力學性能 表面質量 表面粗糙度 表面輪廓

【摘要】：基于FDM工藝,實驗研究了不同分層高度對3D打印制品力學性能和表面質量的影響。結果表明:一定范圍內,隨著分層高度的增加,制品拉伸強度逐漸降低,而斷裂伸長率則逐漸升高;在成型方向上,隨著分層高度的增加,表面粗糙度增加,同時沉積層的表面輪廓由三角形逐漸向半圓形過渡,而垂直于成型方向的輪廓線,無明顯尺寸精度變化,表明與分層高度相關性較小。
[Abstract]:Based on the FDM process, the effects of different layer height on the mechanical properties and surface quality of 3D printing products were investigated experimentally. The results show that within a certain range, with the increase of height, tensile strength decreased, and elongation increased gradually; in the forming direction, stratified as the height increases, the surface roughness increases, and the surface profile of the sediment layer by the triangle gradually to the semicircle transition, and perpendicular to the direction of the contour forming no obvious changes in size, precision, and show that the stratification height correlation is low.
【作者單位】： 青島科技大學機電工程學院;
【分類號】：TB301;TP391.73
【正文快照】： Ejects of Layer Thickness in FDM on Mechanical Properties and Surface Quality of Printed ProductsLIN Guangyi,LIU Feng,ZHAO Huiji.KONG Linwei,YU Xiaodong(College of Mechanical and Electrical Engineering,Qingdao University of Science and Technology,Qingdao

【相似文獻】

相關碩士學位論文 前1條

1 王小峰;氣體輔助注射成型氣體穿透行為和制品力學性能的試驗研究[D];鄭州大學;2007年

，

本文編號：1341489