利用真空飽水法確定粗集料密度
[Abstract]:At present, the density and water absorption test of coarse aggregate are carried out according to AASHTO T85 and ASTM C-127 standard. This method needs to soak the coarse aggregate sample for 15 h (AASHTO T85) and (24 鹵4) h (ASTM C-127), then dry the aggregate surface with dry water absorbent cloth to make it reach dry (SSD) state. The method is subjective in judging whether coarse aggregate meets SSD condition, and too long test time will bring inconvenience to construction quality control and quality monitoring (QC/QA). In this paper, a new vacuum saturated method is proposed to determine the density and water absorption of coarse aggregate. Under the pressure of 30mm mercury (4kPa), the crude aggregate was saturated in vacuum for 10 ~ 20 and 30 min, instead of the traditional immersion time of (24 鹵4) h. The vacuum saturated method for coarse aggregates is to remove all air entrained in the samples and to make water enter the effective pores of coarse aggregates. In this paper, various kinds of aggregates of different properties, including basalt, limestone and sand, are tested. The steel slag and comminuted concrete block are compared with the results obtained by AASHTO T 85. The results show that the measurement of coarse aggregate density under the condition of vacuum saturation of 10 ~ (20) and 30min can replace AASHTO T _ (85). At the same time, an important discovery has been made that AASHTO T85 has the problem of underestimating the water absorption of aggregates compared with the vacuum saturated water method.
【作者單位】: 長安大學交通鋪面材料教育部工程研究中心;陜西中霖建設工程集團有限公司;西安科技大學建筑與土木工程學院;
【基金】:國家自然科學基金資助項目(編號:52108047,52108048) 中國博士后科學基金項目(編號:2013M532005) 河南省交通運輸廳科技計劃項目(編號:2012P35) 河北省交通運輸廳科技計劃項目(編號:Y-2011004,Y-2011005)
【分類號】:U414
【相似文獻】
相關期刊論文 前10條
1 姜華貴;戰琦琦;鐘建國;;基于A(yíng)ASHTO規范算法的橋梁船撞風險評估[J];交通科技與經濟;2009年05期
2 鄧安妍;高建東;杜躍亭;;基于A(yíng)ASHTO模型算法的橋梁船撞風險分析[J];世界橋梁;2011年01期
3 胡春華;黃清麗;;AASHTO連續配筋混凝土路面結構設計方法[J];中國水運(下半月);2011年05期
4 韓喜波;韓喜春;馬士杰;;基于A(yíng)ASHTO規范的舊水泥路面破壞評價方法分析[J];山東交通科技;2012年04期
5 陳利華;;AASHTO道路規范應用分析[J];電力勘測設計;2012年05期
6 韋金城;崔世萍;;基于A(yíng)ASHTO力學經驗設計法的材料參數綜述[J];山東交通科技;2008年01期
7 舒翔;劉宇;;AASHTO2002路面結構設計參數綜述[J];廣東公路交通;2010年01期
8 汪娟;;AASHTO柔性路面設計法在廠礦道路結構設計中的應用[J];山東交通學院學報;2013年02期
9 付建軍;;鉆孔樁施工中國公路規范與AASHTO規范之比較[J];路基工程;2013年06期
10 陳柏年;關于A(yíng)STM和AASHTO“采用核子法測試密度/濕度”標準譯文的說明[J];交通標準化;2001年03期
相關會議論文 前1條
1 劉榴;;談?wù)凙ASHTO/AWS D1.5《橋梁焊接規范》[A];中國鋼結構協會四屆四次理事會暨2006年全國鋼結構學術年會論文集[C];2006年
,本文編號:2182463
本文鏈接:http://www.sikaile.net/kejilunwen/jiaotonggongchenglunwen/2182463.html