電機定子圓柱殼體周向模態頻率計算
發布時間：2019-06-07 08:49
【摘要】：為了研究電機定子圓柱殼體長度、壁厚、平均直徑以及徑厚比對其周向模態頻率的影響,用有限元法對不同參數的圓柱殼體進行了模態分析。通過分析得出圓柱殼體周向模態頻率與其長度關系很小,而與其壁厚近似成線性比例關系,與其平均直徑的平方近似成反比關系。圓柱殼體周向模態頻率變化率近似與徑厚比成線性變化。圓柱殼體的徑厚比越小,模態頻率變化率越低;模態階數越高,模態頻率變化率越低。當圓柱殼體徑厚比較小時,傳統解析公式計算結果誤差較大。為了減少計算誤差,提出一種計算圓柱殼體周向模態頻率的解析方法,通過與有限元仿真和實驗?zāi)B(tài)分析結果對比,驗證了該解析計算方法的有效性。
[Abstract]:In order to study the effects of the length, wall thickness, average diameter and diameter-thickness ratio of the stator cylindrical shell on the circumferential modal frequency of the motor, the modal analysis of the cylindrical shell with different parameters is carried out by using the finite element method. Through the analysis, it is concluded that the relationship between the circumferential modal frequency and the length of the cylindrical shell is very small, but it is approximately linear proportional to its wall thickness and inversely proportional to the square of the average diameter. The frequency change rate of circumferential mode of cylindrical shell is approximately linear with the ratio of diameter to thickness. The smaller the diameter-thickness ratio of the cylindrical shell is, the lower the modal frequency change rate is, and the higher the modal order is, the lower the modal frequency change rate is. When the diameter and thickness of cylindrical shell is small, the error of the traditional analytical formula is large. In order to reduce the calculation error, an analytical method for calculating the circumferential modal frequency of cylindrical shells is proposed. The effectiveness of the analytical method is verified by comparing with the results of finite element simulation and experimental modal analysis.
【作者單位】： 沈陽工業大學機械工程學院;
【基金】：國家自然科學基金(51175350)
【分類號】：TM303.3
[Abstract]:In order to study the effects of the length, wall thickness, average diameter and diameter-thickness ratio of the stator cylindrical shell on the circumferential modal frequency of the motor, the modal analysis of the cylindrical shell with different parameters is carried out by using the finite element method. Through the analysis, it is concluded that the relationship between the circumferential modal frequency and the length of the cylindrical shell is very small, but it is approximately linear proportional to its wall thickness and inversely proportional to the square of the average diameter. The frequency change rate of circumferential mode of cylindrical shell is approximately linear with the ratio of diameter to thickness. The smaller the diameter-thickness ratio of the cylindrical shell is, the lower the modal frequency change rate is, and the higher the modal order is, the lower the modal frequency change rate is. When the diameter and thickness of cylindrical shell is small, the error of the traditional analytical formula is large. In order to reduce the calculation error, an analytical method for calculating the circumferential modal frequency of cylindrical shells is proposed. The effectiveness of the analytical method is verified by comparing with the results of finite element simulation and experimental modal analysis.
【作者單位】： 沈陽工業大學機械工程學院;
【基金】：國家自然科學基金(51175350)
【分類號】：TM303.3
【參考文獻】
相關期刊論文 前3條
1 吳建華;基于物理模型開關磁阻電機定子模態和固有頻率的研究[J];中國電機工程學報;2004年08期
2 王天煜;王鳳翔;;大型異步電動機定子振動與模態分析[J];中國電機工程學報;2007年12期
3 代穎;崔淑梅;宋立偉;;車用電機的有限元模態分析[J];中國電機工程學報;2011年09期
【共引文獻】
相關期刊論文 前10條
1 王e，
本文編號：2494670
本文鏈接：http://www.sikaile.net/kejilunwen/dianlilw/2494670.html
最近更新
教材專著
