【摘要】：隨著科技的發展和民眾生活水平的提高,人們更加關注家居生活的舒適度、安全性,智能家居的普及勢在必行。為此,本文針對智能家居的必備模塊——智能開關,給出了一種集觸摸控制與無線傳輸為一體的智能開關解決方案。論文簡要描述了智能開關的組成和工作原理,給出了以STM32F051C4芯片為核心的智能開關硬件架構,詳細設計了主控制器、觸摸檢測、開/關控制和狀態檢測等電路�；谇度胧讲僮飨到y(tǒng)RT-Thread設計了智能開關的控制軟件,主要包括命令處理模塊、狀態檢測模塊、觸摸控制模塊、在線調試模塊。然后討論了多線程的協調控制問題。最后對智能開關樣機進行了測試,結果表明論文設計達到了技術要求。
[Abstract]:With the development of science and technology and the improvement of people's living standard, people pay more attention to the comfort, safety and popularization of smart home. For this reason, this paper presents a solution of intelligent switch which integrates touch control and wireless transmission for the essential module of smart home-intelligent switch. In this paper, the composition and working principle of intelligent switch are briefly described, and the hardware architecture of intelligent switch based on STM32F051C4 chip is given. The main controller, touch detection, on / off control and state detection circuit are designed in detail. The control software of intelligent switch based on embedded operating system RT-Thread is designed, which includes command processing module, state detection module, touch control module and on-line debugging module. Then the coordinated control problem of multi-thread is discussed. Finally, the intelligent switch prototype is tested, and the results show that the design meets the technical requirements.
【學位授予單位】：西安電子科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM564

【相似文獻】

相關期刊論文 前10條

1 ;China Undertakes Secretariat of ISO/TC1 Screw Thread Technical Committee[J];China Standardization;2004年05期

2 ;Thread-Oriented Online Load Balancing[J];Journal of Shanghai University;1998年03期

3 ;Modal Analysis of Thread off Failure of Oil Round Thread Casing Connection[J];Journal of University of Science and Technology Beijing(English Edition);2001年04期

4 ;滾床滾刀廔速及，

本文編號：2171464