本文選題：多直流落點系統 + 換相失敗��； 參考：《華南理工大學》2014年碩士論文

【摘要】：直流輸電本身所具有的經濟性、高度可控及快速可調的特性，使其在遠距離、大容量輸電和區域電力系統聯網等方面應用廣泛，并逐漸形成了交直流輸電并聯運行、多回直流集中饋入受端系統的復雜電網，以我國南方電網尤為典型。對于多直流落點系統，換相失敗是交直流相互作用下最為典型的問題。至2015年溪洛渡和糯扎渡直流工程投產后，南方電網在“十二五”期間將形成更為復雜的多直流落點系統，某些嚴重故障可能會引起南方電網受端八回直流輸電逆變器同時發生換相失敗，多回直流輸電逆變器的換相失敗特性與功率恢復特性對受端電網的安全穩定運行至關重要。因此對多直流落點系統進行詳細地電磁暫態建模，通過仿真的方法研究直流換相失敗及恢復特性非常必要。 本文首先分析了換相失敗的機理及影響換相失敗和功率恢復過程的主要因素；使用PSCAD/EMTDC仿真軟件，以糯扎渡±800kV特高壓直流工程為例，研究逆變側換流母線電壓變化、逆變側交流系統強度及低壓限流控制（VDCOL）對換相失敗及功率恢復特性的影響。 針對大規模交直流電網電磁暫態仿真精確初始穩態難以確定的問題，提出了一種EMTDC快速建模調試方法，通過分區建模調試的思想將大電網建模問題轉化成小電網進行解決，，使建模效率及模型準確度大大提高。對南方電網“兩渡”直流投產后的2015水平年豐大規劃方式數據進行了動態等值，采用上述方法對等值后系統建立了含全部8回直流詳細模型及500kV主網架的交直流大電網PSCAD/EMTDC電磁暫態仿真模型。 對2015年南方電網多直流落點系統換相失敗特性進行了詳細地EMTDC仿真分析，通過對受端主要500kV站點出線進行故障掃描確定了可能引起多回直流同時換相失敗的站點，并重點對直流逆變站出線典型故障下各直流的響應特性及恢復過程進行了分析。最后對南方電網受端系統500kV北郊站、水鄉站和木棉站分別配置±200Mvar靜止同步補償器（STATCOM）裝置對多直流落點系統換相失敗及恢復特性的影響進行了仿真分析。
[Abstract]:Because of its economical, highly controllable and fast adjustable characteristics, DC transmission has been widely used in long-distance, large-capacity transmission and regional power system networking, and has gradually formed a parallel operation of AC / DC transmission. The complex power grid with multiple DC centralized feed into the receiver system is especially typical in China Southern Power Grid. Commutation failure is the most typical problem under AC / DC interaction for multiple DC drop point systems. By 2015, when the Xiluodu and Nuozhadu DC projects are put into operation, the Southern Power Grid will form a more complex multi-DC landing point system during the 12th Five-Year Plan period. Some serious faults may cause commutative failure of the eight-circuit DC inverter at the receiving end of Southern Power Grid. The commutation failure characteristics and power recovery characteristics of the multi-circuit DC inverter are very important for the safe and stable operation of the receiving power network. Therefore, it is necessary to study the DC commutation failure and recovery characteristics through the detailed electromagnetic transient modeling of multi-DC drop point system. In this paper, the mechanism of commutation failure and the main factors influencing the process of commutation failure and power recovery are analyzed firstly, and the voltage variation of inverter side commutation bus is studied by using PSCAD / EMTDC simulation software, taking Nuozhadu 鹵800kV UHV DC project as an example. The effect of inverter side AC system strength and low voltage current limiting control (VDCOL) on commutation failure and power recovery characteristics. In order to solve the problem that the accurate initial steady-state of electromagnetic transient simulation of large-scale AC / DC power network is difficult to determine, an EMTDC fast modeling and debugging method is proposed, which transforms the modeling problem of large power grid into a small power grid through the idea of zoning modeling and debugging. The efficiency and accuracy of modeling are greatly improved. In this paper, the dynamic equivalence of the 2015 level annual Fengda planning method data after the "two Dudu" DC operation in Southern Power Grid has been carried out. Using the above method, the electromagnetic transient simulation model of PSCAD / EMTDC for large AC / DC power grid with all 8 times DC detailed model and 500 kV main grid is established. A detailed EMTDC simulation analysis on the commutation failure characteristics of multi-DC drop point system in Southern Power Grid in 2015 is carried out. Through fault scanning of the main 500kV station at the receiving end, the stations that may cause multiple DC commutation failures are determined. The response characteristics and recovery process of each DC under typical fault of DC inverter station are analyzed. Finally, the effect of 鹵200Mvar static synchronous compensator (+ 200Mvar) on commutation failure and recovery characteristics of 500kV northern suburb station, water station and kapok station of Southern Power Grid is simulated.
【學位授予單位】：華南理工大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM721.1

【參考文獻】

相關期刊論文 前6條

1 楊大春;劉天琪;李興源;阮仁俊;;VDCOL參數整定的改進對多饋入直流輸電系統暫態穩定性的影響研究[J];四川電力技術;2009年02期

2 何朝榮;李興源;;影響多饋入高壓直流換相失敗的耦合導納研究[J];中國電機工程學報;2008年07期

3 林偉芳;湯涌;卜廣全;;多饋入交直流系統短路比的定義和應用[J];中國電機工程學報;2008年31期

4 黃弘揚;徐政;林f^;;基于故障限流器的直流多饋入受端系統動態分區技術[J];中國電機工程學報;2012年19期

5 陳新琪;顧益磊;裘鵬;劉正富;翁華;徐政;;大規模交直流系統電磁暫態仿真關鍵技術[J];中國電力;2012年12期

6 劉振亞;張啟平;;國家電網發展模式研究[J];中國電機工程學報;2013年07期

本文編號：2034051