關于農村配電臺區的智能化研究
本文關鍵詞: 智能配電臺區 智能配電終端 三相不平衡治理 無功補償 低壓配電自動化 出處:《山東大學》2014年碩士論文 論文類型:學位論文
【摘要】:智能臺區建設是智能電網建設的基礎。但目前配電臺區設備自動化程度較低,不滿足智能電網建設需要。為了適應農村用電發展和用電可靠性、電能質量的新要求,需要對配電臺區進行改造,以適應電網智能化愿景。 本文分析國內外研究現狀,從負荷變化、供需矛盾、新能源接入等方面論述了農村智能配電臺區建設的必要性和重要意義。對智能配電臺區的功能實現進行研究和分析,對智能臺區統一數據平臺和配電智能終端技術進行介紹,指出現有技術在三相不平衡治理、低壓自動化等方面存在的不足。針對這些問題提出臺區三相不平衡治理、低壓自動化、無功補償、智能臺區運維等重要技術方案。重點提出一種利用相間負荷調整型二級漏電保護器調整三相不平衡負荷的新技術。智能二級漏保安裝在配電臺區低壓單相電源T接處,在智能配變終端的控制下實現自動調整,一個配電臺區的智能變終端控制該臺區全部的智能二級漏保。智能二級漏保通訊模塊采用有線或無線方式,與智能配變終端進行電流信息與指令的傳遞。智能配變終端收到各智能二級漏保運行電流后,進行臺區三相負載電流計算,得出三相不平衡度。當智能變終端計算三相電流不平衡率值達到或超過設定值時,根據設定數學運算,確定各漏電保護器所帶單相負載是否需要調整,以及調相方案,命令指定智能二級漏保選相開關動作,實現負載由負荷較重的相轉至負荷較輕的相,使得該低壓網絡的三相負荷始終處于接近最佳平衡的狀態。本文對該方案進行了算法的模擬和驗證。 本文提出的技術方案在居嶺莊臺區進行了改造應用,通過應用前后效果對比,改造后在臺區三相負荷平衡、電壓合格率、供電可靠性方面有顯著提升。運維人員實現了對臺區環境的遠程監控,效果明顯,實現了部分智能化功能。
[Abstract]:The construction of smart station area is the foundation of the construction of smart grid. But at present, the automation degree of the equipment in the distribution station area is low, which does not meet the needs of the smart grid construction. In order to meet the new requirements of rural power development and reliability, power quality, It is necessary to transform the distribution station area to meet the intelligent vision of power grid. This paper analyzes the current research situation at home and abroad, discusses the necessity and significance of the construction of rural intelligent radio station area from the aspects of load change, contradiction between supply and demand, and new energy access, and studies and analyzes the function realization of intelligent distribution station area. This paper introduces the unified data platform and intelligent terminal technology of intelligent station, points out the shortcomings of the existing technology in the aspects of three-phase unbalanced treatment and low-voltage automation, and puts forward the three-phase unbalanced treatment of station area. Low voltage automation, reactive power compensation, This paper puts forward a new technology to adjust the unbalance load of three-phase by using the phase-to-phase load adjusting two-stage leakage protector. The intelligent two-stage leakage protection is installed at the T junction of the low-voltage single-phase power supply in the distribution station area. Under the control of the intelligent distribution transformer terminal, the intelligent transformer terminal in a distribution station area controls all the intelligent secondary leakage protection in the station area. The intelligent secondary leakage protection communication module adopts wired or wireless mode. The intelligent distribution transformer terminal carries on the current information and instruction transmission with the intelligent distribution transformer terminal. After the intelligent distribution transformer terminal receives the operation current of each intelligent secondary leakage protection, it calculates the three-phase load current in the station area. When the intelligent terminal calculates that the unbalance rate of three-phase current reaches or exceeds the set value, according to the set mathematical operation, determines whether the single-phase load of each leakage protector needs to be adjusted, as well as the phase modulation scheme. The command specifies the operation of the intelligent two stage leakage phase selector switch to transfer the load from the heavier phase to the lighter one. The three-phase load of the low-voltage network is always close to the optimal balance. The algorithm is simulated and verified in this paper. The technical scheme put forward in this paper has been applied to the reconstruction of Julingzhuang Tai area. By comparing the effect before and after the application, the three-phase load balance and the qualified voltage rate are obtained after the retrofit. The reliability of power supply has been greatly improved. The operation and maintenance personnel have realized the remote monitoring and control of the environment of the station area, the effect is obvious, and some intelligent functions have been realized.
【學位授予單位】:山東大學
【學位級別】:碩士
【學位授予年份】:2014
【分類號】:TM727.1;TM76
【相似文獻】
相關期刊論文 前10條
1 張春喜;李朝陽;;農網智能化配電臺區建設[J];大眾用電;2012年03期
2 梁榮春;配電臺區未通過驗收的原因及對策[J];農電管理;2002年06期
3 張權銘;;鄉村電網配電臺區建設[J];農村電氣化;2007年01期
4 王帥;張峰;;配電臺區改造及應用[J];農村電氣化;2011年01期
5 岳紅權;吳仰宇;李玉成;;農網智能化配電臺區建設的研究與探討[J];陜西電力;2011年04期
6 張春喜;李朝陽;韓善起;;農網智能化配電臺區建設初探[J];農村電工;2012年02期
7 戴秀標;秦立剛;;智能化配電臺區在山區建設應用[J];農村電氣化;2013年10期
8 盧峰;王震宇;沈駿;章堅民;陳清泰;邢翼;劉笑園;;面向農村電網的智能配電臺區及其應用[J];上海電力學院學報;2014年S1期
9 趙正友,曹志剛,管秋芬;農村配電臺區安裝過程中應注意的一些問題[J];農村電氣化;1998年12期
10 王國強;;農網智能配電臺區建設與實施淺析[J];農村電工;2013年05期
相關會議論文 前4條
1 匡少龍;王立新;;配電臺區的電量電費分析對配電臺區經濟運行的啟示[A];華東六省一市電機(電力)工程學會輸配電技術研討會2006年年會論文集[C];2006年
2 陳雪蓮;廖敏;;贛州電網智能配電臺區通信方式探討[A];2013電力行業信息化年會論文集[C];2013年
3 陳雪蓮;廖敏;;贛州電網智能配電臺區通信方式探討[A];2013電力行業信息化年會論文集[C];2013年
4 張衛東;;縣城配變臺區設計[A];第十五屆華東六省一市電機工程(電力)學會輸配電技術研討會論文集[C];2007年
相關重要報紙文章 前5條
1 羅斌;大悟城區公用配電臺區加裝“雙保險”[N];中國電力報;2005年
2 通訊員 羅斌;專用配電臺區預付費計量裝置引來回頭客[N];中國電力報;2006年
3 劉俊!●T楠;新鄉將對2770個配電臺區進行治理[N];國家電網報;2013年
4 記者 李莉;為工程順利實施創造良好條件[N];周口日報;2008年
5 李文華;滎陽農網完善工程竣工[N];國家電網報;2009年
相關碩士學位論文 前3條
1 高甲勇;關于農村配電臺區的智能化研究[D];山東大學;2014年
2 邢鴻峰;無線配電臺區電能采控系統的設計[D];內蒙古大學;2012年
3 劉衛兵;農村智能配電臺區典型建設方案研究[D];華北電力大學;2012年
,本文編號:1543737
本文鏈接:http://www.sikaile.net/kejilunwen/dianlilw/1543737.html