本文關鍵詞：雙饋感應發電機接入電網的三相短路電流峰值評估　出處：《電力系統自動化》2014年18期 　論文類型：期刊論文

  更多相關文章： 雙饋感應發電機 靜態等值電路 撬棒電阻 轉速 短路電流峰值

【摘要】：短路電流計算是電網規劃和保護的基礎,文中將雙饋感應發電機(DFIG)定子磁鏈強制分量歸算至定子側,將定子磁鏈直流分量歸算至轉子側,形成靜態等值電路,分析轉子感應磁鏈隨轉速的變化規律,研究轉子電阻對故障時定子磁鏈直流分量動態衰減及其與轉子繞組感應過程的影響,推導電網三相短路時DFIG定子短路電流解析式。比較了近端和遠端故障時不同撬棒電阻對應定子短路電流特性,提出了DFIG接入電網的三相短路電流峰值評估方法。該方法能有效計算DFIG機端、饋線上下游和其他饋線故障時的三相短路電流峰值序列,采用MATLAB/Simulink軟件仿真驗證了所提出方法的正確性。
[Abstract]:Short circuit current calculation is the basis of power grid planning and protection, the doubly fed induction generator (DFIG) stator flux forced component reduction to the stator, the stator flux of DC component reduction to the rotor side, forming a static equivalent circuit analysis of rotor flux variations with the rotational speed of the rotor resistance of stator fault the flux of DC component of dynamic attenuation and its influence and the rotor winding of the induction process, derived when three-phase short-circuit fault DFIG stator short-circuit current formula. Comparison of the proximal and distal faults of different corresponding stator crowbar resistance short-circuit current characteristics, method of three-phase short-circuit current peak grid DFIG evaluation is proposed. This method can effectively calculate the DFIG machine at the end of the peak, three-phase short-circuit current series feeder and other downstream feeder fault, verify the correctness of the proposed method by MATLAB/Simulink simulation software.

【作者單位】： 輸配電裝備及系統安全與新技術國家重點實驗室 重慶大學;廣東電網公司珠海供電局;
【基金】：國家自然科學基金資助項目(51277184) 國家高技術研究發展計劃(863計劃)資助項目(2011AA05A107)~~
【分類號】：TM31
【正文快照】： 0引言雙饋感應發電機(doubly-fed inductiongenerator,DFIG)以其靈活的控制性能,在風力發電系統中應用廣泛。電網短路時DFIG機端電壓下降,在定子繞組產生沖擊電流,對于大部分商用DFIG機組,須在轉子側接入合適的撬棒電阻,以保護DFIG和實現低電壓穿越運行[1-2]。短路電流計算是

【相似文獻】

相關期刊論文 前2條

1 高滿茹;;低壓大功率異步電動機對三相短路電流的影響[J];建筑電氣;2010年03期

2 王玉卿;王振聲;王莉;;大型數據中心低壓柴油發電機組配電系統短路電流計算[J];智能建筑電氣技術;2007年01期

，

本文編號：1414426