鋰離子電池陶瓷復合全固態電解質的制備和性能研究
發布時間:2018-07-15 14:40
【摘要】:以負載Al_2O_3的無紡布為支撐膜,浸涂PEO-LAGP-SN-Li TFSI的乙腈共混液干燥后制得新型復合固態電解質膜(CLASP)。該膜的熱穩定性好,即使在170℃的高溫下依然不發生形變。當浸涂共混液中PEO:LAGP:SN:Li TFSI為3:1:1:1,固含量為10wt%時,室溫電導率可以達到3.66×10~(-5) S/cm,100℃時電導率可達2.52×10~(-4) S/cm.CLASP膜的電化學窗口寬,以該膜代替液態電解質裝配的全固態LiFePO_4/CLASP/Li電池,在55℃循環時表現出良好的循環穩定性,高的庫倫效率,有望成為電化學性能優越的全固態電解質。
[Abstract]:A novel composite solid-state electrolyte membrane (clasp) was prepared by drying the acetonitrile blend solution of PEO-LAGP-SN-Li TFSI with the non-woven Al2O3 bearing fabric as the supporting membrane. The film has good thermal stability and does not deform even at 170 鈩,
本文編號:2124411
[Abstract]:A novel composite solid-state electrolyte membrane (clasp) was prepared by drying the acetonitrile blend solution of PEO-LAGP-SN-Li TFSI with the non-woven Al2O3 bearing fabric as the supporting membrane. The film has good thermal stability and does not deform even at 170 鈩,
本文編號:2124411
本文鏈接:http://www.sikaile.net/kejilunwen/dianlidianqilunwen/2124411.html
最近更新
教材專著