【摘要】：目的研究下頜第一前磨牙僅用纖維樁主樁和主樁與輔樁聯合應用時,牙體及修復體所受應力大小分布的影響。方法選擇19顆正常的離體下頜第一前磨牙,應用錐形束CT(CBCT)掃描,獲取圖像,選取扁形單根管前磨牙1顆,經根管治療及樁道預備此牙后,再次以相同條件進行CBCT掃描,利用三維有限元法建立只應用主樁的分析模型A及主樁與輔樁聯合應用的模型B,分析不同載荷情況下牙體和修復體上的應力大小及分布情況。結果當受到與牙體長軸成相同角度的載荷時,模型A和模型B的牙體組織和樁上的應力大小及分布無明顯差異。同等大小的載荷,隨著加載角度增大,模型A和模型B牙體組織上應力均明顯增大。結論輔樁對修復體應力的影響不大,但隨著加載角度的增大,修復體上應力明顯增大。
[Abstract]:Objective to study the effect of stress distribution on the mandibular first premolars when the primary post and the main post combined with the auxiliary post were used only in the first premolars of the mandible. Methods 19 normal mandibular first premolars in vitro were scanned with cone-shaped CT (CBCT), and one flat single-root premolar was selected. After root canal therapy and post canal preparation, CBCT scanning was performed under the same conditions. The three-dimensional finite element method is used to establish the analytical model A of the main pile and the model B of the combination of the main post and the auxiliary post. The stress size and distribution on the tooth and the prosthetic body under different loads are analyzed. Results there was no significant difference in stress size and distribution between model A and model B under the loading of the same angle as the long axis of tooth, and there was no significant difference in stress distribution between model A and model B. With the increasing of the loading angle, the stress on the tooth tissue of model A and model B increases obviously with the loading of the same size. Conclusion the influence of the auxiliary pile on the stress of the repaired body is not obvious, but with the increase of the loading angle, the stress on the repaired body increases obviously.
【作者單位】： 鄭州大學第一附屬醫院口腔修復科;許昌市中心醫院口腔科;
【分類號】：R783

【相似文獻】

相關碩士學位論文 前1條

1 王慶;主樁與輔樁聯合應用對扁形根管的前磨牙修復后應力影響的有限元分析[D];鄭州大學;2014年

，

本文編號：2450433