本文關鍵詞： 聚苯胺 微乳液聚合 十二烷基苯磺酸 摻雜 電導率 水性環氧樹脂 耐蝕性　出處：《電鍍與涂飾》2016年22期 　論文類型：期刊論文

【摘要】：采用微乳液聚合法,以十二烷基苯磺酸(DBSA)和鹽酸(HCl)為摻雜劑、OP-10為助乳化劑、過硫酸銨為氧化劑,制備了聚苯胺懸浮液。探討了主要原料用量和工藝參數對聚苯胺電導率的影響,確定最優反應條件為:n(DBSA):n(HCl)=3:2,n(酸):n(苯胺)=2:1,n(氧化劑):n(苯胺)=1:1,m(OP-10):m(苯胺)=2:3,反應時間9 h,反應溫度30℃。將所制聚苯胺懸浮液直接與水性環氧乳液混合均勻后加入配套固化劑,通過電化學測量和浸泡試驗研究了所得涂層的防腐性能。結果表明其防腐性能相比純環氧涂層得到非常大的提高。
[Abstract]:Microemulsion polymerization was carried out with 12 alkylbenzenesulfonic acid (DBSA) and hydrochloric acid (HCl) as co-emulsifiers and ammonium persulfate as oxidant. Polyaniline suspension was prepared, and the effects of main raw materials and technological parameters on the conductivity of Polyaniline were discussed. The optimum reaction conditions were determined as follows: 1: nn DBSA: 1 / n HClN / 3: 2. Aniline (aniline) 2: 1 (aniline 1: 1) OP-10: M (aniline 2: 3, reaction time 9 h.). The reaction temperature was 30 鈩，

本文編號：1461382