本文選題：傾斜噴涂　切入點：犄角曲面　出處：《機械設計與制造》2016年11期

【摘要】：針對傾角噴涂工藝時的涂層生長速率建模問題,提出運用高斯和模型建立噴槍靜態傾角噴涂時的涂層生長速率模型。基于高斯和模型,首先運用微分幾何放大定理建立考慮噴涂?jī)A角為變量的涂層生長速率模型;然后做噴槍靜態傾角噴涂實驗,運用最小二乘法對離散點的涂層厚度進行擬合,最終建立基于高斯和模型的傾角噴涂涂層生長速率模型。最后運用基于β分布模型的傾角噴涂涂層生長速率模型擬合離散點的涂層厚度,通過對比得到基于高斯和模型的傾角噴涂涂層生長速率模型更能獲得較好的擬合精度。
[Abstract]:Aiming at the modeling of coating growth rate in dip spraying process, a model of coating growth rate during static dip spraying with Gao Si and model is proposed. The model of coating growth rate considering spray dip angle as variable is established by differential geometric amplification theorem, and then the spray gun static dip spraying experiment is done, and the coating thickness of discrete point is fitted by least square method. Finally, the growth rate model of dip spray coating based on Gao Si and model is established. Finally, the growth rate model of dip spray coating based on 尾 distribution model is used to fit the coating thickness of discrete point. The growth rate model of dip spray coating based on Gao Si and model can obtain better fitting accuracy.
【作者單位】： 鹽城工學院機械工程學院;安徽理工大學機械工程學院;鹽城工學院汽車工程學院;
【基金】：國家自然科學基金(51405418) 江蘇省高校自然科學基金(14KJB460031)
【分類號】：TQ639.2;TP242
，

本文編號：1665841