本文選題：分形理論 + 調制識別�。� 參考：《河北大學學報(自然科學版)》2014年06期

【摘要】：針對數字調相和調頻識別問題,提出采用調制信號絕對值的瞬時幅度的盒維數作為多進制數字相位調制(MPSK)和多進制數字頻率調制(MFSK)信號類間識別的特征參數,并采用擬合曲線作為判決門限,該方法在保持具有較少的特征參數的同時還增強了對噪聲的魯棒性.在調制信號的類內識別中,分別采用MPSK信號的瞬時相位的盒維數和MFSK信號的瞬時頻率的盒維數作為特征參數.仿真結果表明,在信噪比為5dB時,對信號進行完全識別的正確率可以達到90%以上,從而證明了該方法的有效可行性.
[Abstract]:In order to solve the problem of digital phase modulation and frequency modulation recognition, the box dimension of the absolute value of modulation signal is used as the characteristic parameter of MPSKs and MFSKs, which can be recognized by multi-ary digital phase modulation (MPSKK) and multi-ary digital frequency modulation (MFSKK). The fitting curve is used as the decision threshold. This method not only keeps less characteristic parameters, but also enhances the robustness to noise. The box-dimension of instantaneous phase of MPSK signal and the dimension of instantaneous frequency of MFSK signal are used as characteristic parameters in in-class recognition of modulation signal. The simulation results show that when the SNR is 5dB, the correct rate of complete recognition can reach more than 90%, which proves the validity of the method.
【作者單位】： 河北大學電子信息工程學院;
【基金】：河北省自然科學基金資助項目(F2013201170)
【分類號】：TN911.3
，

本文編號：1938815