本文選題：油井采出液　切入點：含水率　出處：《石油工業技術監督》2016年12期 　論文類型：期刊論文

【摘要】：油井采出液含水率的測量是油田開發中一項十分重要的工作,針對目前油井采出液人工取樣存在的含水率波動大、取樣代表性差、取樣人員勞動強度大、效率低等問題,研制了油井采出液自動取樣器。該取樣器通過加大單剖面斜度或多孔道式取樣頭,增大了取樣剖面,提高了取樣代表性,防殘液回流裝置保證了油井采出液取樣的真實性。現場試驗表明,該取樣器取樣穩定性好,含水波動基本在2%左右,比人工取樣更具代表性,更能反映油井真實含水。
[Abstract]:The measurement of water cut of oil well produced liquid is a very important work in oilfield development. In view of the problems of large fluctuation of water cut rate, poor representativeness of sampling, large labor intensity and low efficiency, etc, artificial sampling of oil well produced liquid exists at present. An automatic sampler for producing fluid from oil wells has been developed. The sampler increases the sampling profile and the sampling representativeness by increasing the slope of a single profile or a multi-pass sampling head. Field test shows that the sampling stability is good and the fluctuation of water cut is about 2%, which is more representative than manual sampling and can reflect the true water cut of oil well.
【作者單位】： 國家石油天然氣大流量計量站東營分站;
【分類號】：TE937

【相似文獻】

相關期刊論文 前6條

1 周永璋;曾建民;張堅;;油井采出液成分與溫度對Q235鋼腐蝕行為的影響[J];機械工程材料;2008年12期

2 吳亞Z，

本文編號：1638484