鋸齒形切屑的形成會導致機床振動,使刀具的切削性能下降,降低工件的加工質量,因此需要對其形成機理進行分析,合理優化切削參數,減少鋸齒形切屑的形成機率。本文利用ABAQUS軟件對鈦合金的加工過程進行仿真分析,模擬鋸齒形切屑的形成機理,并在不同切削條件下進行仿真和實驗研究,討論切削參數對切屑鋸齒化程度的影響。結果表明,隨著切削速度和進給量的增加,切屑的鋸齒化程度逐漸增大,隨著刀具前角的增大,切屑的鋸齒化程度逐漸減小。研究結果對提高工件加工質量以及設計工藝參數有一定指導作用。

【文章頁數】：6 頁

【文章目錄】：
1 Introduction
2 Forming mechanism and geometric characterization of serrated chip
    2.1 Mechanism of serrated chip formation
    2.2 Geometric characterization of chip morphology
        2.2.1 Chip thickness compression ratio
        2.2.2 Degree of serration
3 Establishment and analysis of finite element model
    3.1 Simulation model
    3.2 Establish of the constitutive model
    3.3 Analysis of simulation results
4 Experimental tests
    4.1 Influence of cutting speed on serrated degree
    4.2 Influence of feed rate on serrated degree
    4.3 Influence of tool rake angle on serrated degree
5 Conclusions



本文編號：3976630