【摘要】：采用X射線衍射儀、光學顯微鏡、掃描電鏡、透射電鏡和拉伸試驗研究了澆注溫度和T6熱處理對擠壓鑄造Mg-6Zn-0.1Ca-0.5Mn(ZX60)合金組織和力學性能的影響。研究表明,鑄態合金的相組成為Mg基體和第二相MgZn_2相。隨著澆注溫度由720℃降低至680℃,鑄態組織枝晶間距減小,連續、粗大的第二相趨向于彌散分布,合金屈服強度提高但抗拉強度和伸長率下降。ZX60鎂合金經T6熱處理后,主要強化相為沿[0001]_Mg分布的桿狀MgZn_2相,其屈服強度、抗拉強度和伸長率相對于鑄態分別提高了122%、62%和32%。
[Abstract]:The effects of pouring temperature and T6 heat treatment on the microstructure and mechanical properties of squeeze casting Mg-6Zn-0.1Ca-0.5Mn (ZX60) alloy were investigated by X-ray diffractometer, optical microscope, scanning electron microscope, transmission electron microscope and tensile test. The results show that the phase composition of the as-cast alloy is Mg matrix and second phase MgZn_2 phase. With the decrease of pouring temperature from 720 鈩，

本文編號：2340595