本文選題：激光熔覆 + 鎳基涂層　； 參考：《焊接學報》2015年05期

【摘要】：文中采用SYSWELD軟件分別對激光單道和搭接熔覆過程進行模擬分析.結果表明,激光熔覆處理時經歷了快速加熱、快速冷卻的過程,具有較高的過熱度,單道處理時熔覆層表面中心點峰值溫度最高,可達2 589℃;隨著遠離熔池中心,各點峰值溫度逐漸降低.激光單道處理后,熔覆層內受拉應力,最大值出現熔覆層與基體交界處,熱影響區受壓應力.搭接處理后第一道熔覆層仍受拉應力,但拉應力值明顯降低,最大值在熱影響區.由于第一道熔覆的預熱作用,第二道各點峰值溫度均高于單道處理,應力最大值出現在靠近熔覆層底部位置,而熱影響區受壓應力.
[Abstract]:In this paper, the laser single channel and lap cladding processes are simulated and analyzed by SYSWELD software. The results showed that the laser cladding process experienced the process of rapid heating and rapid cooling, and had a higher superheat degree. The peak temperature of the surface center point of the cladding layer was the highest, up to 2 589 鈩，

本文編號：1779280