本文關鍵詞： 電火花加工 多孔質電極 復雜型腔 沖液　出處：《上海交通大學學報》2015年10期 　論文類型：期刊論文

【摘要】：通過制備符合電火花加工要求的多孔質電極并搭建實驗系統,對多孔質電極在深孔條件下的電火花加工性能進行了實驗研究.結果表明,在工件上表面加工較淺的型腔時,多孔質電極與實體電極的材料去除率相差不大;而在工件上表面加工深孔時,多孔質電極能夠以不抬刀的方式進行加工,使其加工效率得到提高,且加工速度不受加工深度的影響;對于較大深度的半封閉復雜型面加工,采用多孔質電極不僅能夠提高其粗加工效率,而且可以利用沖液以避免碳柱的產生.
[Abstract]:Through the preparation of porous electrode with electric spark processing requirements and set up the experimental system, the porous electrode in deep hole under the condition of EDM performance were studied. The results show that the cavity on the workpiece surface shallow, porous electrode and solid electrode material removal rate difference not on the surface of workpiece; deep hole machining, porous electrode can be processed to knife the way, so that the processing efficiency is improved, and the processing speed is not affected by the depth of processing; for larger depth of semi closed complex surface machining, the porous electrode can not only improve the rough machining the efficiency, but also can use the washing liquid to avoid carbon column.

【作者單位】： 江南大學機械工程學院江蘇省食品先進制造裝備技術重點實驗室;
【基金】：國家自然科學基金項目(51205169)資助
【分類號】：TG661

【參考文獻】

相關期刊論文 前4條

1 趙萬生;劉晉春;袁哲俊;增l⒙【，

本文編號：1546398