【摘要】：為了尋找一種適用于汽油機渦輪增壓器高溫環境下使用的合金材料,選用IN713C合金作為研究對象,旨在探索最佳的IN713C注射成形工藝參數。對制備樣品的密度、微觀組織結構和力學性能進行測試和分析,發現850℃是較佳的預燒溫度;當燒結溫度為1 300℃,保溫時間為3 h時,樣品密度、硬度和拉伸性能最佳,燒結密度為7.83 g/cm~3,,相對密度為99.0%。
[Abstract]:In order to find an alloy material suitable for use in a high-temperature environment of a gasoline engine turbocharger, the IN713C alloy is used as the research object, and the optimal IN713C injection molding process parameters are explored. The density, microstructure and mechanical properties of the prepared sample were tested and analyzed, and it was found that 850 鈩，

本文編號：2525857