【摘要】：對AZ31鎂合金進行了恒溫超塑性壓縮和恒溫超塑性固態焊接試驗,研究了AZ31鎂合金在大氣環境下恒溫超塑性固態焊接可行的工藝參數。結果表明:溫度對恒溫超塑性固態焊接接頭強度影響較大,時間的影響其次,應變速率的影響相對較小。恒溫超塑性固態焊接過程中組織發生了動態再結晶,并能在更省能源、省時間的條件下,達到與擴散焊相當?shù)慕宇^剪切強度。在預壓應力30 MPa、焊接溫度450℃、應變速率為1×10~(-4) s~(-1)的條件下,經13 min壓接,可實現AZ31鎂合金的超塑性連接,剪切強度達到42.08 MPa。
[Abstract]:Constant temperature superplastic compression and constant temperature superplastic solid state welding experiments were carried out on AZ31 magnesium alloy. The feasible process parameters of AZ31 magnesium alloy in atmospheric environment were studied. The results show that the influence of temperature on the strength of superplastic solid-state welded joints at constant temperature is greater than that of time and the effect of strain rate is relatively small. Dynamic recrystallization occurs in the process of superplastic solid-state welding at constant temperature, and the shear strength of the joint can reach the equivalent of diffusion welding under the condition of saving energy and time. Under the condition of pre-compression stress 30 MPa, welding temperature 450 鈩，

本文編號：2421218