【摘要】：以錫青銅連桿襯套為研究對象,通過Deform-3D軟件進行了數值模擬。利用單一因素工藝參數試驗法和正交試驗優化試驗方法對發動機連桿襯套的溫?cái)D壓過程進行了數值模擬分析,得到了摩擦因數、溫?cái)D壓速度、溫?cái)D壓溫度等參數在溫?cái)D壓過程中對擠壓力、損傷值的影響規律和顯著性影響。利用極差分析得到了兩組最優的溫?cái)D壓工藝參數,并通過數值模擬兩組較優解對擠壓力、損傷值的影響規律的對比,最終得到一組最優解,即摩擦因數為0.1、溫?cái)D壓速度為5 mm·s-1、溫?cái)D壓溫度為700℃。根據連桿襯套溫?cái)D壓試驗驗證了使用優化后的工藝參數能夠制造出表面質量高的成形件。
[Abstract]:The tin bronze connecting rod bushing was numerically simulated by Deform-3D software. The temperature extrusion process of engine connecting rod bushing was simulated and analyzed by single factor process parameter test method and orthogonal test optimization test method. The friction coefficient and temperature extrusion speed were obtained. The influence of temperature and other parameters on the extrusion force and damage value in the process of warm extrusion is significant. By means of range analysis, two groups of optimal warm extrusion process parameters are obtained. By comparing the effects of two groups of optimal solutions on extrusion pressure and damage value, a group of optimal solutions, that is, friction coefficient of 0.1, is obtained. The temperature extrusion temperature is 700 鈩，

本文編號：2325281