發布時間：2018-08-02 08:15

【摘要】：采用真空熱擴散滲鋁的方法對AZ31鎂合金進行表面合金化處理,在不同參數下得到厚度不一的滲鋁層,對滲層的顯微組織、物相組成進行了分析,并分析了滲鋁試樣的耐腐蝕性能和顯微硬度.繪制了AZ31鎂合金基體以及經過400℃擴散滲鋁4 h后的試樣的極化曲線.結果表明,滲層主要由Mg17Al12,Mg3Al2和α-Mg等組成,滲層厚度隨擴散溫度提高而增加,400℃恒溫?zé)釘U(kuò)散4 h時,在基體表面獲得了連續且均勻細密的滲鋁層,顯微硬度值從基體的53 HV提高到80~85 HV,同時,該方法使得鎂合金的自腐蝕電位提高了約105 m V,而鎂合金的自腐蝕電流密度降低了一個數量級,這表征著鎂合金的耐蝕性能得到提高.
[Abstract]:The surface alloying of AZ31 magnesium alloy was carried out by vacuum thermal diffusion aluminizing. The aluminizing layer with different thickness was obtained under different parameters. The microstructure and phase composition of the layer were analyzed. The corrosion resistance and microhardness of aluminized samples were analyzed. The polarization curves of AZ31 magnesium alloy matrix and the sample after 4 h diffusion aluminizing at 400 鈩，

本文編號：2158783