本文選題：顆粒增強金屬基復合材料 + 多邊形管電極��； 參考：《現代制造工程》2017年11期

【摘要】：針對顆粒增強金屬基復合材料的加工難題以及采用中空管電極電火花打孔排屑等問題,提出了采用多邊形中空管電極電火花法加工該類材料。分別采用截面為圓形和五邊形的兩種中空管電極,對比研究不同顆粒增強金屬基復合材料加工的效率。利用正交試驗法研究顆粒增強金屬基復合材料中不同加工參數對加工效率的影響,得到了多邊形中空電極電火花加工的最佳工藝參數。試驗結果表明,截面為五邊形的中空電極較圓形中空電極電火花加工效率高,加工時間最大縮短51.8%;正交試驗的最佳工藝組合為脈沖寬度32ms,占空比2∶3,峰值電流7A。
[Abstract]:In order to solve the problem of machining particle reinforced metal matrix composites and to use middle hollow tube electrode to drill holes and remove chips, a polygonal hollow tube electrode EDM method is proposed to process this kind of materials. Two kinds of hollow tube electrodes with circular section and pentagonal section were used to study the machining efficiency of different particle reinforced metal matrix composites. The effects of different machining parameters on machining efficiency in particulate reinforced metal matrix composites were studied by orthogonal test. The optimum processing parameters of polygonal hollow electrode EDM were obtained. The experimental results show that the hollow electrode with pentagonal cross section is more efficient than circular hollow electrode in EDM, and the processing time is shortened by 51.8.The optimum process combination of orthogonal experiment is pulse width 32ms, duty cycle 2: 3, peak current 7A.
【作者單位】： 廣東工業大學機電工程學院;
【基金】：國家自然科學基金項目(51675105,51575113,51205137) 廣東省高層次人才特殊支持計劃科技創新青年拔尖人才項目(2014TQ01X542)
【分類號】：TB331;TG661
，

本文編號：2116953