發布時間：2018-04-19 10:58

  本文選題：釬焊 + 非晶釬料　； 參考：《材料熱處理學報》2017年03期

【摘要】：為改善YG8硬質合金與45鋼的焊接性能,采用Cu_(39.37)Ti_(32.19)Zr_(19.38)Ni_(9.06)(at%)非晶態釬料對YG8硬質合金和45鋼進行釬焊。通過XRD、SEM、萬能試驗機對釬料的微觀結構以及釬焊接頭形貌、析出相和力學性能進行分析。結果表明:在一定釬焊溫度下,隨釬焊時間的增加,接頭強度逐漸減小,有明顯的裂紋,且裂紋在YG8硬質合金一側反應層中萌生并擴展。在釬焊溫度900℃,釬焊時間10 min時獲得的抗拉強度最高,約為250 MPa。焊接頭強度與YG8硬質合金一側形成的反應層厚度有關。通過計算得到了反應層厚度形成的激活能Q和反應層生長速度A_0。
[Abstract]:In order to improve the weldability of YG8 cemented carbide and 45 steel, the YG8 cemented carbide and 45 steel were brazed with YG8 cemented carbide and 45 steel.The microstructure, morphology, precipitate phase and mechanical properties of brazing joint were analyzed by XRDX SEM and universal testing machine.The results show that with the increase of brazing time, the strength of the joint decreases and there are obvious cracks at a certain brazing temperature, and the crack initiation and propagation in the reaction layer on the side of the YG8 cemented carbide.When the brazing temperature is 900 鈩，

本文編號：1772808