發布時間：2018-02-26 11:35

  本文關鍵詞： 金銀銅合金 時效處理 顯微組織 硬度　出處：《熱加工工藝》2017年22期 　論文類型：期刊論文

【摘要】：采用真空熔煉、軋制和固溶處理,然后冷加工75%制備Au Ag Cu35-5合金片材。研究合金固溶和時效處理對組織和力學性能的影響。結果表明:500℃固溶處理時,合金組織為纖維狀回復再結晶結構。隨固溶溫度增加,組織發生完全再結晶并長大,形成貫穿晶粒的完整退火孿晶。爐冷和時效處理時,組織為等軸細小的球形晶粒。合金的硬度隨固溶溫度升高而降低,時效硬度隨溫度升高而增大。300℃時效時,硬度在3 h時效時達到峰值,然后隨時間增加,緩慢降低。
[Abstract]:Au Ag Cu35-5 alloy sheet was prepared by vacuum melting, rolling and solution treatment, and then cold worked on 75%. The effect of solution and aging treatment on microstructure and mechanical properties was studied. The microstructure of the alloy is fibrous recovery recrystallization structure. With the increase of the solution temperature, the microstructure completely recrystallizes and grows, forming the complete annealing twin through the grain. The hardness of the alloy decreases with the increase of solution temperature. When aging temperature increases at .300 鈩，

本文編號：1537864