本文關鍵詞： 半固態(tài) Al-Si合金 內冷式攪拌法 初生α-Al　出處：《特種鑄造及有色合金》2017年11期 　論文類型：期刊論文

【摘要】：采用內冷式攪拌法制備了Al-7Si半固態(tài)漿料,研究在不同熔體攪拌初始溫度、攪拌頭質量占比、攪拌速率、取樣溫度下合金半固態(tài)組織的變化,以及對初生α-Al平均晶粒尺寸和形狀因子的影響,分析了內冷式攪拌生成細小近球形組織的機理。結果表明,在熔體攪拌初始溫度為625℃,攪拌頭質量為5%,攪拌速率為1 200r/min,取樣溫度為600℃時,能夠制備出初生α-Al晶粒細小圓整的半固態(tài)漿料,其平均晶粒尺寸和形狀因子分別可以達到64.21μm和0.649 0。
[Abstract]:Al-7Si semi-solid slurry was prepared by internal cooling stirring method. The microstructure of semi-solid alloy was studied at different melt stirring temperature, mixing head mass ratio, stirring rate and sampling temperature. The effect of the average grain size and shape factor on the average grain size and shape factor of primary 偽 -Al was analyzed. The mechanism of formation of fine near-spherical microstructure by internal cooling stirring was analyzed. The results showed that the initial temperature of melt stirring was 625 鈩，

本文編號：1505468