本文關鍵詞： TC鈦合金 熱處理 擴散層 熱應力 結合力　出處：《稀有金屬材料與工程》2017年02期 　論文類型：期刊論文

【摘要】：采用化學鍍方法在TC4鈦合金表面制備了Ni-P鍍層,通過不同的退火溫度處理試件,研究了影響鍍層結合力的影響因素。用SEM分析了不同溫度處理后鍍層的結構從而建立不同熱處理溫度、保溫時間與擴散層厚度的動力學方程;采用X射線衍射研究了擴散界面的產物及不同退火溫度對鍍層的熱應力的影響。結果表明:400℃,2h、400℃,4h熱處理之后無擴散層出現;在500℃,2 h、500℃,4 h、600℃,2 h、600℃,4 h、700℃,2 h、700℃,4 h熱處理后均出現擴散層,并根據擴散層的厚度與熱處理溫度和時間的關系推導出其擴散的動力學方程:y=2.72 exp(-6353/T)t;不同溫度熱處理后Ni-P鍍層的熱應力顯著增加;熱處理后鍍層的結合力有所增加,400℃,2h、400℃,4h、500℃,4h熱處理后鍍層與基體的結合力最好。
[Abstract]:The Ni-P coating was prepared on the surface of TC4 titanium alloy by electroless plating. The samples were annealed at different temperatures. The influence factors on the adhesion of the coating were studied. The structure of the coating after different temperature treatment was analyzed by SEM, and the dynamic equations of different heat treatment temperature, holding time and diffusion layer thickness were established. The effect of the product of diffusion interface and different annealing temperature on the thermal stress of the coating was studied by X-ray diffraction. The results show that there is no diffusion layer after 4 h heat treatment at 1: 400 鈩，

本文編號：1443344