本文選題：硅樹脂　切入點：預固化　出處：《人工晶體學報》2017年07期

【摘要】：采用硅樹脂RSN-6018為陶瓷先驅體,并引入一定比例的預固化硅樹脂,在N_2氣氛下于1200℃裂解轉化制備組分單一、孔結構可控以及陶瓷產率高的硅氧碳(Si-O-C)多孔陶瓷,研究了預固化硅樹脂含量對Si-O-C多孔陶瓷微觀形貌和性能的影響。結果表明:預固化硅樹脂的加入可有效調節Si-O-C多孔陶瓷的孔形貌、孔徑以及氣孔率,當預固化硅樹脂含量低于90wt%時,隨著預固化硅樹脂含量的增加,孔結構從貫通圓孔變?yōu)轭w粒"搭接"貫通孔,再變?yōu)轭w粒堆積孔,且氣孔率增大;而體積收縮減小,陶瓷產率提高;耐壓強度在27.9~17.5 MPa之間。
[Abstract]:Silica resin RSN-6018 was used as ceramic precursor, and a certain proportion of precured silicone resin was introduced to prepare Si-O-C porous ceramics with single component, controllable pore structure and high ceramic yield by pyrolysis and transformation at 1200 鈩，

本文編號：1667202