【摘要】：采用傳統固相法制備了平均晶粒尺寸為5μm的四方結構摻鑭鋯鈦酸鉛(PLZT)鐵電陶瓷,在其表面涂銀、切向預極化后刻蝕出刻槽,在刻槽表面壓出維氏壓痕并沿預極化方向施加外電場,利用Raman光譜原位觀測了壓痕裂紋尖端附近不同位置的疇變,分析了Raman軟模E(2TO)和E(3TO+2LO)+B1峰的強度隨觀測點的變化規律。結果表明:在外電場作用下,裂紋尖端會發生電致應變和90°疇變;Raman譜和軟模E(2TO)、E(3TO+2LO)+B1峰強度均會隨著觀測點距裂紋尖端距離的增大而減弱。
[Abstract]:The tetragonal (PLZT) ferroelectric ceramics with average grain size of 5 渭 m were prepared by conventional solid state method. Silver was coated on the surface of the ceramics, and the grooves were etched after tangential prepolarization. Vickers indentation was indented on the surface of the groove and applied an external electric field along the prepolarization direction. The domain switching near the crack tip of the indentation was observed in situ by Raman spectroscopy. The variation of the intensity of E (2TO) and E (3TO 2LO) B1 peaks with the observed point is analyzed. The results show that the electric strain and 90 擄domain switching will occur at the crack tip under the external electric field, and both the Raman spectrum and the soft mode E (2TO), E (3TO 2LO) B1 peak intensity will decrease with the increase of the distance from the observation point to the crack tip.
【作者單位】： 廈門大學材料學院 福建省特種先進材料重點實驗室;
【基金】：國家自然科學基金資助項目(51302236) 福建省自然科學基金資助項目(2014J01205)
【分類號】：TQ174.1

【相似文獻】

相關期刊論文 前7條

1 ;φ1010mm容器電測試驗[J];化工與通用機械;1977年12期

2 R.R.Barr;周則恭;;COD的量測方法及其在估計缺陷影響中的應用[J];化工與通用機械;1978年11期

3 李曉冬,王燕斌,褚武揚,田芳,王琛,白春禮;云母表面加載裂紋尖端的AFM研究[J];金屬學報;1997年06期

4 張正國;;平面應變COD公式之修正[J];化學工程師;1988年02期

5 陳四利;吳海鈺;史建軍;孫海霞;;混凝土復合型裂紋等ε_(tái)θ線形狀應變能準則[J];建筑材料學報;2012年02期

6 張清純,林素貞;β-Al_2O_3固體電解質的“電解—應力腐蝕”裂紋生長[J];無機材料學報;1989年01期

7 ;[J];;年期

，

本文編號：2312643