試樣傾斜對陶瓷材料儀器化壓入測試結果影響的有限元分析
發(fā)布時間:2018-06-06 00:23
本文選題:儀器化壓入 + 陶瓷材料 ; 參考:《陶瓷學報》2016年05期
【摘要】:針對目前常用的儀器化壓入測試方法——Oliver-Pharr方法和Ma方法,通過有限元數值分析軟件,分析了儀器化壓入測試中試樣表面不同傾斜角度對彈性模量識別結果的影響。結果表明,基于Oliver-Pharr方法和Ma方法識別的陶瓷材料彈性模量隨著試樣表面傾斜角度的增加而增加,當試樣小角度(≤3°)傾斜時,識別誤差可控制在5%以內,影響較小;當傾斜角度等于4°時,Oliver-Pharr方法的最大識別誤差為6.88%,Ma方法的最大識別誤差為6.79%,此時試樣表面的傾斜對彈性模量識別的影響較大。因此,進行儀器化壓入試樣的表面加工時,要保證試樣表面的平整度,不宜出現過大傾斜角,以滿足測試精度要求。
[Abstract]:In view of the commonly used instrumentation indentation test methods Oliver-Pharr method and Ma method, the influence of different inclination angles of specimen surface on the identification results of elastic modulus in instrumented indentation test is analyzed by finite element numerical analysis software. The results show that the elastic modulus of ceramic materials based on Oliver-Pharr method and Ma method increases with the increase of the inclined angle of the sample surface. When the sample is tilted at a small angle (鈮,
本文編號:1984110
本文鏈接:http://www.sikaile.net/kejilunwen/huagong/1984110.html
教材專著