本文選題：柔性受壓　切入點：電鑄　出處：《中國有色金屬學報》2017年04期

【摘要】：在鎢絲增強鎳的電鑄制造過程中,利用柔性壓緊輪補充電沉積區域的電鑄液,并摩擦與擠壓復合電鑄層,以提高鎢絲-鎳復合電鑄層的抗拉強度。研究柔性受壓條件對復合電鑄層表面形貌、斷口形貌和抗拉強度的影響。結果表明:柔性壓緊輪對復合電鑄層的摩擦與擠壓作用顯著減少表面孔隙并細化晶粒;其輸送電鑄液的作用能夠防止復合電鑄層內部出現空洞;柔性受壓條件對復合電鑄層抗拉強度的提升效果隨著鎢絲體積分?jǐn)?shù)的增加而越發顯著,當鎢絲體積分?jǐn)?shù)為50%時,抗拉強度提升18%,達到1558 MPa。
[Abstract]:In the electroforming process of tungsten wire reinforced nickel, the flexible compaction wheel was used to replenish the electroforming solution in the electrodeposition area, and the composite electroforming layer was rubbed and extruded. In order to improve the tensile strength of tungsten wire / nickel composite electroforming layer, the surface morphology of composite electroforming layer under flexible compression condition was studied. The results show that the friction and extrusion effects of flexible compaction wheel on the composite electroforming layer can significantly reduce the surface porosity and refine the grain size, and the effect of the electroforming solution can prevent the formation of voids in the composite electroforming layer. The effect of flexible compression on the tensile strength of composite electroforming layer is more and more remarkable with the increase of tungsten wire volume fraction. When the volume fraction of tungsten wire is 50, the tensile strength increases by 18% to 1558 MPA.
【作者單位】： 無錫職業技術學院機械技術學院;
【基金】：國家自然科學基金資助項目(51505192) 江蘇高等學校優秀科技創新團隊項目 江蘇省高�！扒嗨{(lán)工程”優秀青年骨干教師培養項目~~
【分類號】：TQ153.4
，

本文編號：1667661