發布時間：2018-02-20 16:06

  本文關鍵詞： 含Li廢渣 LiCO HSO浸出 NaOH除雜及EDTA深度除雜 NaCO沉鋰 回收工藝　出處：《稀有金屬與硬質合金》2017年04期 　論文類型：期刊論文

【摘要】：針對含Li廢渣中Li資源得不到充分利用的問題,采用H_2SO_4浸出、NaOH除雜及EDTA深度除雜、Na_2CO_3沉鋰工藝從含Li廢渣中回收制備Li_2CO_3。實驗結果表明,優化的工藝參數為:H_2SO_4酸浸過程,H_2SO_4濃度5%(體積分數)、浸出溫度70℃、浸出時間60min;NaOH除雜及EDTA深度除雜過程,加入NaOH至酸浸液pH值為12,之后加入2.0g/L的固體EDTA進行深度除雜;Na_2CO_3沉鋰過程,溶液中Li+濃度23g/L,Na_2CO_3濃度為300g/L、用量為理論量的1.10倍,水浴溫度95℃,反應時間40min。在優化工藝參數條件下,制備出的Li_2CO_3各項指標基本達到Li_2CO_3-0級要求,且Li綜合回收率達到95%以上。
[Abstract]:In order to solve the problem that Li resources are not fully utilized in the waste residue containing Li, Li _ 2CO _ 3 is prepared by H _ S _ 2SO _ 4 leaching of NaOH and EDTA deep impurity removal and Na2CO _ 3 precipitated lithium from the waste residue containing Li. The experimental results show that Li-2CO _ 3 is prepared from the waste residue containing Li. The optimized technological parameters are as follows: 1% H2SO4 acid leaching process (volume fraction, leaching temperature 70 鈩，

本文編號：1519390