發布時間：2018-01-06 01:05

  本文關鍵詞：微波毫米波寬帶功分放大模塊研究　出處：《電子科技大學》2015年碩士論文　論文類型：學位論文

  更多相關文章： 微波毫米波 寬帶放大 平面混合集成電路

【摘要】：無論是軍事領域還是民用產品,作為無線通信和電子偵察系統關鍵組成部分之一的寬帶放大器越來越受到各國重視,整個無線通信系統的性能好壞直接取決于它。本文研究了一個具有四個功分放大通道的微波毫米波寬帶功分放大模塊,包括L波段(1.2GHz)通道,S、C、X波段(2-18GHz)通道,K波段(20.2GHz)通道以及K、Ka波段(22-40GHz)通道。具體工作內容如下:1.對微波毫米波寬帶放大技術的研究背景和研究意義作了簡要介紹,并列舉了在微波毫米波寬帶放大領域國內外的發展動態。2.簡要介紹了放大器的基本理論知識,包括:放大器的種類和用途、放大器的基本結構以及微波毫米波放大器的主要技術指標等,為接下來對微波毫米波寬帶功分放大模塊的設計提供理論支持。3.首先詳細分析了微波毫米波寬帶功分放大模塊的各項技術指標,然后依據技術指標要求,分別對四個通道:2-18GHz寬帶功分放大通道、1.2GHz點頻功分放大通道、22-40GHz寬帶功分放大通道以及20.2GHz點頻功分放大通道提出了初步設計方案,并對設計原理進行了詳細分析。4.利用Ansoft HFSS仿真軟件對設計方案中所使用的無源器件-功分器進行仿真,包括:22-40GHz通道功分器,20.2GHz和2-18GHz通道功分器。5.結合初步設計方案進行單片器件選型,并對所選用的部分單片器件(如HMC463、CHA2097a等)分別設計加工出驗證模塊進行單獨驗證,并依據測試結果完成最終方案設計。然后結合最終設計方案完成其它拓撲電路的設計工作,包括2-18GHz通道和1.2GHz通道功分放大鏈路的偏置電路與檢波電路設計、22-40GHz通道和20.2GHz通道功分放大鏈路的偏置電路與檢波電路設計以及整個微波毫米波寬帶功分放大模塊的比較電路設計等。6.對兩個單元模塊分別進行測試,并對測試結果進行分析。測試工作完成之后,將2-18GHz通道和1.2GHz通道功分放大鏈路單元模塊、22-40GHz通道和20.2GHz通道功分放大鏈路單元模塊以及整個微波毫米波寬帶功分放大模塊的比較電路進行裝配,最后完成整個系統的歸一化供電工作。7.對本文的主要工作進行了總結,指出了不足之處,并提出了下一步工作展望。
[Abstract]:Whether military or civilian products, as the key system of wireless communication and electronic reconnaissance. Part of the broadband amplifier more and more national attention, the performance of the whole wireless communication system depends directly on it. This paper has a four power on channel microwave and millimeter wave broadband power amplifier module, including L band (1.2GHz) channel, S, C, X band (2-18GHz) channel, K channel and K band (20.2GHz), Ka band (22-40GHz) channel. The specific works are as follows: 1. on the microwave amplification technology of millimeter wave broadband background and significance of the research are briefly introduced, and lists in the microwave and millimeter wave broadband amplification.2. developments in the field at home and abroad are briefly introduced. The basic theoretical knowledge, including the types and uses of amplifier amplifier, amplifier basic structure and main technology of microwave and millimeter wave amplifier The index, the technical indicators to provide theoretical support for the design of.3. next to the microwave and millimeter wave broadband power amplifier module of the first detailed analysis of the microwave and millimeter wave broadband power amplifier module, then according to the technical requirements, each of the four channels: 2-18GHz broadband power amplifier channel, 1.2GHz frequency power amplifier channel. 22-40GHz broadband power divider preliminary design amplifier amplification channel and 20.2GHz channel frequency power, and the design principle of a detailed analysis of.4. using Ansoft HFSS simulation software used to design the source device - power splitter is simulated, including: 22-40GHz channel power divider, 20.2GHz and 2-18GHz channel. Is.5. with the preliminary design scheme of monolithic device selection, and on the part of the monolithic device (such as HMC463, CHA2097a etc.) were designed and manufactured for the separate test verification module Based on the testing results, completed the final design. Then combined with the final design to complete the design work of other topologies, including the design of bias circuit and detection circuit of 2-18GHz channel and 1.2GHz channel power amplifying link, design of bias circuit and detection circuit of 22-40GHz channel and 20.2GHz channel power amplifying link and the microwave and millimeter wave broadband power amplifier module circuit design comparison of two.6. modules were tested, and the test results are analyzed. After the test is completed, 2-18GHz channel and 1.2GHz channel power amplifying link unit module, the comparison circuit of 22-40GHz channel and 20.2GHz channel power amplifying link unit module and the broadband microwave and millimeter wave power amplifier module assembly, finally completed the main work of the whole system of the normalized power supply of the.7. In this paper, the shortcomings are pointed out, and the future work prospect is put forward.

【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN722.75

【參考文獻】

相關期刊論文 前1條

1 劉自明,李淑芳;國內外微波毫米波單片集成電路的現狀和發展趨勢[J];半導體技術;1992年03期

，

本文編號：1385611