本文選題：瀝青混凝土攤鋪機 + 振搗夯錘�。� 參考：《長安大學》2015年碩士論文

【摘要】：瀝青混凝土攤鋪機的作業參數一直是人們關注的焦點,然而目前對瀝青混凝土攤鋪機作業參數尚沒有深入系統的研究,瀝青混凝土攤鋪機生產廠家和施工單位針對不同攤鋪厚度及材料都無法給出合適的作業參數。針對這種現象,采用理論與試驗相結合的研究方法,對瀝青混凝土攤鋪機面層施工作業參數進行了理論分析和試驗研究,為瀝青混凝土攤鋪機作業參數的確定提供參考。首先,根據國家和行業標準的相關規定,以及對現場工地實際作業參數的統計分析,初步確定了作業參數的選取范圍。然后,提出瀝青混凝土攤鋪機振搗夯錘重疊度和有效接觸寬度的概念,依次從理論上確定了瀝青混凝土攤鋪機作業參數的取值。其次,分別以不同松鋪厚度對瀝青混凝土攤鋪機作業速度,熨平板振搗梁振幅,重疊度,以及熨平板振動擊實功等對瀝青混凝土攤鋪機作業參數的合理性進行了試驗研究,對比不同作業參數下的作業質量,進一步確定了作業參數的選取范圍。最后,以國內某高速路段為案例,按照試驗得出的作業參數進行了面層攤鋪?zhàn)鳂I(yè),通過與施工方原有參數方案的試鋪結果對比,驗證了研究所的作業參數合理可行的。
[Abstract]:The operating parameters of asphalt concrete paver have always been the focus of attention. However, there is no deep and systematic study on the operating parameters of asphalt concrete paver. The manufacturer and construction unit of asphalt concrete paver can not give proper operation parameters according to different spreading thickness and material. In view of this phenomenon, using the research method of combining theory with experiment, the paper makes a theoretical analysis and experimental study on the operating parameters of asphalt concrete paver surface layer, which provides a reference for determining the operation parameters of asphalt concrete paver. Firstly, according to the relevant regulations of national and industry standards, and the statistical analysis of site actual operating parameters, the selection range of operational parameters is preliminarily determined. Then, the concepts of overlap degree and effective contact width of vibratory tamping hammer of asphalt concrete paver are put forward, and the operating parameters of asphalt concrete paver are determined theoretically. Secondly, the rationality of the operation parameters of asphalt concrete paver, such as the working speed of asphalt concrete paver, the amplitude of ironing plate vibrating beam, the overlap degree, and the work of ironing plate vibration compaction, are studied respectively with different loose spreading thickness. The selection range of operation parameters is further determined by comparing the operation quality with different job parameters. Finally, taking a high-speed road section in China as a case, the paving operation of surface layer is carried out according to the operation parameters obtained from the test. By comparing with the test results of the original parameter scheme of the construction side, it is proved that the operational parameters of the research institute are reasonable and feasible.
【學位授予單位】：長安大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：U415.521

【參考文獻】

相關期刊論文 前5條

1 張毅;;控制高速公路瀝青混凝土路面壓實質量的措施[J];公路;2007年10期

2 劉國強;;ATB—25瀝青混凝土柔性基層施工工藝研究[J];交通標準化;2013年14期

3 ;連續不間斷攤鋪工藝與瀝青混合料轉運車[J];交通世界(建養.機械);2010年11期

4 張碧琴,張志友,李冰,張超群;瀝青混合料轉運車作業質量[J];筑路機械與施工機械化;2005年09期

5 魏振豹;;SMA瀝青面層施工技術[J];中國高新技術企業;2013年12期

相關博士學位論文 前1條

1 李冰;瀝青混凝土路面施工工藝及機群協同作業[D];長安大學;2004年

相關碩士學位論文 前1條

1 謝飛云;瀝青混凝土路面鋪層均勻性評價[D];重慶交通大學;2011年

，

本文編號：1919465