本文選題：鎢銅復合材料 + 坯體　； 參考：《稀有金屬與硬質合金》2017年04期

【摘要】：利用非水基體系凝膠注模法制備了復雜形狀鎢銅復合材料坯體。研究了分散劑含量以及固相含量對鎢銅漿料黏度的影響,繪制了坯體的室溫干燥曲線并制訂了干燥制度,同時對坯體微觀形貌、抗彎強度等進行了表征和測試。結果表明:分散劑添加量為0.15%(質量分?jǐn)?shù),基于金屬粉末質量)時漿料黏度達到最低,在此基礎上漿料的固相含量可達到45%(體積分?jǐn)?shù)),滿足凝膠注模的要求;坯體先在室溫下干燥10h后放入100℃的恒溫干燥箱中干燥8h,可得到表面無變形、無開裂的鎢銅坯體;隨著固相含量的增大,坯體致密性和均勻性均隨之提高;坯體表面質量較好,抗彎強度可達到26.9 MPa。
[Abstract]:The complex shape tungsten-copper composite billets were prepared by non-aqueous system gel injection. The effects of dispersant content and solid content on the viscosity of tungsten copper paste were studied. The drying curve at room temperature was drawn and the drying system was worked out. Meanwhile, the microstructure and bending strength of the billet were characterized and tested. The results showed that the viscosity of the slurry reached the lowest when the amount of dispersant was 0.15 (mass fraction, based on the mass of metal powder), and the solid content of the slurry could reach 45% (volume fraction), which met the requirement of gel injection. After drying at room temperature for 10 h and then drying in a 100 鈩，

本文編號：1894708