丁集煤礦煤層瓦斯基礎參數及抽采影響半徑測試研究
[Abstract]:In this paper, according to the actual situation of gas occurrence in 11-2 coal seam and 13-1 coal seam in Dingji Coal Mine, the gas foundation parameters of 11 ~ 2N ~ (13) ~ (-1) coal seam are obtained by testing. By comparing the permeability coefficient of the two coal seams with the standard of extraction difficulty, it is concluded that the difficulty degree of extracting coal seam at the # 11-2 coal seam and the 13-1 coal seam borehole is forced extraction. It can be seen from the field test that the pressure drop method is a simple and effective method for determining the influence radius of borehole pumping through the bottom layer. In this paper, the testing principle and concrete method of pressure drop method are studied, and the field test of this method is carried out in Dingji Coal Mine. The test results are as follows: 13-1 coal seam in Dingji Coal Mine is using hole diameter 94mmm drainage borehole to carry out coal seam gas drainage. When the suction negative pressure is 24 KPA and the extraction time is 43 days, the influence radius of extraction is 4 m, and the influence radius is 5 m after 51 days of extraction. The test results show that 11-2 coal seam is using 94mm borehole to extract coal seam gas, when the suction negative pressure is 24 KPA, and the extraction time is 36 days, The influence radius of gas extraction is 3 m, and the influence radius is 4.5 m in 47 days and 5 m after 54 days of gas extraction. According to the relation between the extraction time and the radius, the arrangement of drilling holes in the floor of coal seam No. 13-1 in 11-2 coal seam is optimized, and the interval between the adjacent two pre-pumping boreholes is optimized to be 10 m spacing. The invalid overlap of boreholes in the coal seam during the design and construction is avoided. The test results provide an important basis for gas extraction and prevention in Dingji Coal Mine.
【學位授予單位】:安徽理工大學
【學位級別】:碩士
【學位授予年份】:2013
【分類號】:TD712
【參考文獻】
相關期刊論文 前10條
1 易麗軍;俞啟香;;低透氣性煤層瓦斯抽采增流技術[J];礦業安全與環保;2005年06期
2 王路珍;杜春志;卜萬奎;柳紅燕;;煤層鉆孔孔壁瓦斯涌出的數值模擬[J];礦業安全與環保;2008年06期
3 殷德銀;;穿層鉆孔抽放瓦斯效果考察[J];礦業安全與環保;2009年02期
4 徐三民;確定瓦斯有效抽放半徑的方法探討[J];煤炭工程師;1996年03期
5 唐兵;司春風;孟賢正;;鉆孔瓦斯抽采半徑的確定方法及實踐[J];礦業安全與環保;2012年04期
6 劉澤功,戴廣龍,石必明,盧平,涂敏;影響采空區頂板抽放瓦斯效果的主要因素分析[J];安徽理工大學學報(自然科學版);2003年04期
7 張興武;;顧橋礦穿層鉆孔抽放影響半徑試驗研究[J];淮南職業技術學院學報;2011年04期
8 周紅星,程遠平,謝戰良;計算機模擬確定瓦斯抽放有效半徑的方法研究[J];能源技術與管理;2005年04期
9 李建兵;陳向軍;;瓦斯抽采鉆孔有效影響半徑測定[J];能源技術與管理;2012年03期
10 趙楠;季淮君;李雨佳;;關于測定煤層瓦斯抽放影響半徑的試驗研究[J];江西煤炭科技;2011年03期
,本文編號:2154371
本文鏈接:http://www.sikaile.net/kejilunwen/anquangongcheng/2154371.html