本文選題：軸向加載-橫向卸載　切入點：含瓦斯煤　出處：《煤礦安全》2017年12期 　論文類型：期刊論文

【摘要】：為了模擬煤礦工作面前方應力變化時含瓦斯煤體的力學特性,應用RFPA~(2D)-Flow軟件模擬研究了軸向加載-橫向卸載作用下含瓦斯煤的變形破裂規律,討論了初始圍壓、軸壓和卸載速率效應對試樣變形破壞的影響。研究結果表明:在加載和卸載方向,軸向應力和橫向應力初期都呈線性增加,當達到極限強度后煤體的變形破裂導致急劇的應力降,直至煤樣失去承載能力時基本保持恒定。初始圍壓、軸壓越大,卸載速率越小,煤體的極限抗壓、拉強度及其對應的軸向、橫向應變越大;峰值強度及應變與初始圍壓、軸壓呈明顯的線性相關性,而與卸載速率表現出階梯狀,隨著卸載速率的增加極限強度及應變減小速率逐漸降低。
[Abstract]:In order to simulate the mechanical characteristics of gas-bearing coal under the change of stress in the front of coal face, the deformation and fracture law of gas-bearing coal under axial loading and transverse unloading is simulated by using RFPA~(2D)-Flow software, and the initial confining pressure is discussed. The effect of axial compression and unloading rate on the deformation and failure of specimens. The results show that the axial stress and transverse stress increase linearly in the direction of loading and unloading. When the ultimate strength is reached, the deformation and rupture of the coal body lead to sharp stress drop, until the coal sample loses its bearing capacity, the initial confining pressure, the greater the axial pressure, the smaller the unloading rate, the lower the ultimate compressive strength of the coal body, the higher the initial confining pressure, the greater the axial pressure, and the smaller the unloading rate. The tensile strength and its corresponding axial direction, the transverse strain is larger, the peak strength and strain have obvious linear correlation with the initial confining pressure and axial pressure, while the axial pressure has a ladder shape with the unloading rate. With the increase of unloading rate, the limit strength and strain decrease rate gradually decrease.
【作者單位】： 中國礦業大學安全工程學院;青島理工大學安全科學與工程系;
【基金】：國家自然科學基金資助項目(51504140) 江蘇省普通高校學術學位研究生科研創新計劃資助項目(KYLX16-0572) 中國礦業大學大學生創新基金資助項目(DC201609)
【分類號】：TD712

【相似文獻】

相關期刊論文 前2條

1 李振聲;;牙輪鉆機轉矩和軸壓的計算[J];礦山機械;1983年06期

2 張榮寬;;回轉扭矩與軸壓關系的定量分析——對60—RⅢ牙輪鉆機的現場測試[J];礦山機械;1979年03期

相關碩士學位論文 前1條

1 付啟超;含瓦斯煤蠕變滲流規律與微觀結構響應[D];河南理工大學;2016年

，

本文編號：1624067