【摘要】：研究堿含量和玻璃粉含量對堿激發礦渣-玻璃粉膠凝材料強度的影響,運用Design Expert軟件的響應面分析法對上述因素建立強度預測模型。結果表明,玻璃粉摻量對膠砂強度的影響不明顯,而堿含量對強度的影響較大,堿含量和玻璃粉的交互作用對抗折強度有一定的影響。當堿含量為7%,玻璃粉含量為5%時,膠砂的強度最高,且得到的最優配比與實測值差異不大,使用響應面分析法可以很好指導堿激發膠凝材料的制備,選出最優配合比。
[Abstract]:The effect of alkali content and glass powder content on the strength of slag-glass powder cementitious material induced by alkali was studied. The strength prediction model was established by using the response surface analysis method of Design Expert software. The results show that the content of glass powder has no obvious effect on the strength of cement sand, while the content of alkali has a great effect on the strength, and the interaction between alkali content and glass powder has some influence on the strength of cement sand. When the content of alkali is 7 and the content of glass powder is 5, the strength of cement sand is the highest, and there is no difference between the optimum ratio and the measured value. The method of response surface analysis can be used to guide the preparation of alkali-excited cementing material and select the best mix ratio.
【作者單位】： 重慶交通大學交通土建工程材料國家地方聯合工程實驗室材料科學與工程學院;
【基金】：國家自然科學基金青年基金項目(51502029) 重慶市科委基礎科學與前沿技術研究項目(cstc2017jcyj AX0417)
【分類號】：TU528

【相似文獻】

相關期刊論文 前2條

1 馬海樂;劉瑞光;王振斌;顧順;;響應面法優化醋糟厭氧發酵制氫[J];農產品加工(學刊);2009年10期

2 肖正強;蔣柏泉;張華;;石英光纖表面鎳-磷-硼預鍍層上電鍍厚鎳的響應面法研究[J];電鍍與涂飾;2011年12期

，

本文編號：2331441