本文選題：粘合劑 + 六層瓦楞紙板��； 參考：《大連工業大學》2014年碩士論文

【摘要】：隨著現代化的腳步,包裝產品的質量問題日益受到關注。金屬包裝、紙包裝、塑料包裝產品的強度問題也因而漸漸引起爭議。其中紙包裝產品中的瓦楞紙板包裝的強度問題正是目前研究的熱點。瓦楞紙板包裝強度一方面取決于構成紙板的原紙的強度,一方面則取決于添加到紙板中的粘合劑,粘合劑固化后的強度因其成分的不同而大有所異。目前市場上正大量使用的是淀粉粘合劑,因其成本低環保而受到一致認可。但是淀粉粘合劑涂布后的紙箱的強度還遠遠不足,在運輸過程中存在很大的風險,容易對內裝物造成破壞,進而損害客戶的利益,影響企業的信譽度。本課題意在研究能用于瓦楞紙板的熱硬性樹脂粘合劑,使其從紙板強度提高率和經濟適用性分析兩方面都能滿足要求,使得高強度瓦楞紙板的強度能與發達國家的相比較,進而提高企業的效益。 本論文對瓦楞紙板進行相關分類,并對其紙板的生產工藝和粘合劑的黏合工藝進行闡述。以四層復合瓦楞紙板作為原材料,對其進行不同種類的粘合劑的涂布。將木薯淀粉粘合劑、水玻璃、CP88淀粉粘合劑、聚乙烯醇粘合劑、聚醋酸乙烯酯粘合劑分別涂布于復合瓦楞中,并對生產完成的四層復合瓦楞紙板進行邊壓強度和平壓強度測試,最終得出水玻璃的邊壓強度和平壓強度為最優選擇。 使用origin軟件對研究的數據進行繪圖,origin作為數據分析軟件之一,能夠清楚的分析出由于實驗因素不同而產生不同結果的原因,并對多種因素產生的不同結果相比較。本課題采用origin從圖中能夠準確的比較和分析四層復合瓦楞紙板強度提高率,并更加確定了水玻璃為強度提高率最大的粘合劑。 同時本課題也對五種粘合劑進行了經濟技術分析,從成本方面再次驗證,強度提高率較大的水玻璃經濟適用性也最佳,從而為企業贏得更多的利潤。
[Abstract]:With the step of modernization, the quality of packaging products has been paid more and more attention. Metal packaging, paper packaging, plastic packaging product strength also gradually aroused controversy. The strength of corrugated board packaging in paper packaging products is the focus of current research. The packaging strength of corrugated board depends on the strength of the base paper, on the other hand, on the adhesive added to the paperboard. At present, starch adhesives are widely used in the market, because of its low cost and environmental protection. However, the strength of carton coated with starch adhesive is still far from enough, and there is a great risk in the transportation process, which can easily damage the contents, and then damage the interests of customers and affect the reputation of enterprises. The purpose of this paper is to study the thermosetting resin binder which can be used in corrugated paperboard, so that it can meet the requirements in terms of strength improvement rate and economic applicability analysis, so that the strength of high strength corrugated board can be compared with that of developed countries. And then improve the efficiency of the enterprise. In this paper, corrugated board is classified, and the production process and adhesive bonding process of corrugated board are described. Four-layer composite corrugated board was used as raw material to coat it with different kinds of binder. Tapioca starch binder, sodium silicate cp 88 starch adhesive, polyvinyl alcohol binder and polyvinyl acetate binder were respectively coated in the composite corrugated, and the edge compression strength and compressive strength of the four layers of composite corrugated paperboard were tested. Finally, it is concluded that the edge compression strength and the compressive strength of sodium silicate are the best choice. As one of the data analysis software, origin software is used to draw the origin of the studied data. It can clearly analyze the causes of different results due to different experimental factors, and compare the different results of many factors. In this paper, origin is used to accurately compare and analyze the strength improvement rate of four-layer composite corrugated board, and the water glass is more determined as the binder with the greatest strength improvement rate. At the same time, the economic and technical analysis of five kinds of binders is also carried out. It is proved again from the cost that the economic applicability of sodium silicate with high strength improvement rate is the best, so as to win more profits for enterprises.
【學位授予單位】：大連工業大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TQ433.43;TB48

【參考文獻】

相關期刊論文 前10條

1 李靖宇;杜仕國;施冬梅;曾勝;;紅外隱身涂料粘合劑的研究進展[J];表面技術;2009年04期

2 高德,劉壯,董靜,常江;瓦楞紙板包裝材料的性能及其發展前景[J];包裝工程;2005年01期

3 韓春陽;王銳;孫炳新;;冷法H_2O_2氧化制備瓦楞紙板用淀粉粘合劑及改性研究[J];包裝工程;2008年07期

4 何自芬;張印輝;;基于有限元法的包裝箱抗壓性能研究[J];包裝工程;2009年03期

5 趙榮麗;李克天;王梅;何衛鋒;;4層瓦楞紙板生產工藝及涂膠機構設計的研究[J];包裝工程;2009年03期

6 郭曉紅;郭紅革;趙菲;;單組分熱固化聚氨酯膠粘劑的研制[J];包裝工程;2010年01期

7 趙榮麗;李克天;王梅;何衛鋒;潘宣澤;;4層瓦楞紙板性能研究[J];包裝工程;2010年09期

8 林朝榮;;包裝用木薯黃糊精粘合劑的研制[J];包裝工程;2011年07期

9 安美清;幾種膠粘劑的性質比較及其在包裝中的應用[J];包裝與食品機械;2005年03期

10 李春偉;王桂英;陳春晟;;手孔對瓦楞紙箱抗壓強度的影響[J];東北林業大學學報;2008年06期

，

本文編號：1865691